51 Channel GPS Module with Patch Antenna on top

	GPS Module wit Patch on Top antenna for navigation Discount: Qty Discounts Off Price 5-9 $63.78 10-24 $60.43 25-99 $57.07 100+ $53.71
	Availibility: In Stock Warranty: None Model: RKI-1505 Downloads: Datasheet Software
Price: $67.14 Only Quantity:

GPS Module comes with a POT (Patch On Top) ceramic antenna which makes it a small and complete solution for enabling GPS navigation to your embedded devices and robots. It supports 51 Channels and external antenna input compatibility for maximum sensitivity. Module comes with a standard 2mm DIP pin headers which provides easy interface to your device. The module works on TTL Serial protocol which used with any microcontroller or PC.

GPS Module Features

• Dimension： 26mm x 26mm x 11.7mm
• Patch Antenna Size：25mm x 25mm x 4mm
• Low Power Consumption：55mA @ acquisition, 40mA @ tracking
• L1 Frequency, C/A code, 51-channel
• High Sensitivity：Up to -158 dBm tracking, superior urban performances1
• Position Accuracy：Without aid: 3m 2D-RMS
• DGPS(RTM,SBAS(WAAS,EGNOS,MASA)):2.5m 2D-RMS
• Cold Start is Under 36 seconds (Typical)
• Warm Start is Under 34 seconds (Typical)
• Hot Start is Under 1 second (Typical)
• Data output Baud rate：9600 bps(Default), 4800/9600/14400/19200/38400/57600/115200
• Max. Update Rate：5Hz (Default: 1 Hz)
• Pin header Connection for easy to assemble

GPS Module Pinouts

• VCC (Pin1) - The main DC power supply is DC 3.3V±5% for the module.
• GND (Pin2) - The analog ground and digital ground for the module.
• RX (Pin3) - This is the UART receiver of the module. It is used to receive software commands and firmware update.
• TX (Pin4) - This is the UART transmitter of the module. It outputs the GPS information for application.
• V-ANT (Pin5) - The power supply is DC 2.7V to 3.3V for the External Antenna input pin(Pin8). The maximum consumption current for the GPS antenna is limited to 30mA.
• GND(Pin6) - The analog ground and digital ground for the module.
• RESET(Pin7) - This pin is Reset pin, the pin is active Low, the pin will keep high when power on. If you don’t want to control the pin , please keep no connection (N/C)
• EXANT(Pin8) - This pin is External Antenna input pin.

• Model: RKI-1505

Product 1/4