Home :: GSM/GPRS/GPS/RFID :: USB/UART GPS Module 66 Channel with Patch Antenna on top

USB/UART GPS Module 66 Channel with Patch Antenna on top

larger image

This module can connect to Microcontroller or USB of computer directly

Availibility:	In Stock
Warranty:	1 Month
Model:	RKI-1510
Downloads:	Datasheet Software Driver

Price: $48.00 $40.00 Only

Quantity:

GPS Module comes with a POT (Patch On Top) ceramic antenna which makes it a small and complete solution for enabling GPS navigation to your embedded devices and robots. It supports 66 Channels and external antenna input compatibility for maximum sensitivity. Module comes with a standard 2mm DIP pin headers which provides easy interface to your device. The module works on TTL Serial protocol which used with any microcontroller or PC. USB cable is included to connect with PC USB port.

It can be directly pluged to USB and can be connected to softwares like trimble studio.

GPS Module Features

Dimension： 16mm x 16mm x 6mm (Full circuit 80mm x 23mm x 12mm)
Patch Antenna Size：15mm x 15mm x 4mm
Low Power Consumption：55mA @ acquisition, 40mA @ tracking
L1 Frequency, C/A code, 51-channel
High Sensitivity：Up to -158 dBm tracking, superior urban performances1
Position Accuracy：Without aid: 3m 2D-RMS
DGPS(RTM,SBAS(WAAS,EGNOS,MASA)):2.5m 2D-RMS
Cold Start is Under 36 seconds (Typical)
Warm Start is Under 34 seconds (Typical)
Hot Start is Under 1 second (Typical)
Data output Baud rate：9600 bps
Max. Update Rate：5Hz (Default: 1 Hz)
Pin header Connection for easy to assemble

USB GPS Module Pinouts

GND (Pin1) - Ground
VCC (Pin2) - +5V input or if module is connected to USB +5V output
TX (Pin3) - This is the UART transmitter of the module. It outputs the GPS information for application.
RX (Pin4) - This is the UART receiver of the module.