Dual Motor Driver (Electronic 5 Amp)

larger image

Just add this motor driver to your control circuit and drive 2 big DC motors upto 5 Amps. Suitable for RC cars, Microcontroller/PC based circuits. It can also control a 4/6 wire stepper in Bipolar Mode.

Availibility:	In Stock
Warranty:	6 Months
Model:	RKI-1004
Downloads:

Price: $5.00 Only

Quantity:

This is a ready to use dual H bridge module for controlling 2 DC motors with 5 Amp capacity each or a Stepper motor at max. 5 amp/phase. These motor drivers can be used to control any small to big motors. High speed PWM is also supported. It can be directly connected to 4 microcontroller pins to control 2 DC motor or a Stepper motor in Bipolar mode.

Features

5 Amp. per motor capacity
Works with any circuit that gives 3 to 5 v high output
Soft Start and Stop provides long life to gearboxes.

Usage

Connect the 6 wires to circuits and 4 wires to Motors.
Upon giving the battery/power supply to circuit it will drive the motors as per the input from RC circuit / Microcontroller / PC output or any other circuit that gives 3-5 V output.
Pinouts:
- Output section (Screwed connector)
  - Pin 1 : Motor 1 a
  - Pin 2 : Motor 1 b
  - Pin 3 : Motor 2 a
  - Pin 4 : Motor 2 b
- Input Section (6 Pin male Header)
  - Pin 1 : Motor 1 + forward
  - Pin 2 : Motor 1 - reverse
  - Pin 3 : Motor 2 + forward
  - Pin 4 : Motor 2 + reverse
  - Pin 5 : +5 V output (For external circuits like MCU Board)
  - Pin 6 : GND