USB/UART GPS Module 66 Channel with Patch Antenna on top

	This module can connect to Microcontroller or USB of computer directly
	Availibility: In Stock Warranty: 1 Month Model: RKI-1510 Downloads: Datasheet Software Driver
Price: $48.00  $40.00 Only Quantity:

GPS Module comes with a POT (Patch On Top) ceramic antenna which makes it a small and complete solution for enabling GPS navigation to your embedded devices and robots. It supports 66 Channels and external antenna input compatibility for maximum sensitivity. Module comes with a standard 2mm DIP pin headers which provides easy interface to your device. The module works on TTL Serial protocol which used with any microcontroller or PC. USB cable is included to connect with PC USB port.

It can be directly pluged to USB and can be connected to softwares like trimble studio. 

GPS Module Features

• Dimension： 16mm x 16mm x 6mm (Full circuit 80mm x 23mm x 12mm)
• Patch Antenna Size：15mm x 15mm x 4mm
• Low Power Consumption：55mA @ acquisition, 40mA @ tracking
• L1 Frequency, C/A code, 51-channel
• High Sensitivity：Up to -158 dBm tracking, superior urban performances1
• Position Accuracy：Without aid: 3m 2D-RMS
• DGPS(RTM,SBAS(WAAS,EGNOS,MASA)):2.5m 2D-RMS
• Cold Start is Under 36 seconds (Typical)
• Warm Start is Under 34 seconds (Typical)
• Hot Start is Under 1 second (Typical)
• Data output Baud rate：9600 bps
• Max. Update Rate：5Hz (Default: 1 Hz)
• Pin header Connection for easy to assemble

USB GPS Module Pinouts

• GND (Pin1) - Ground
• VCC (Pin2) - +5V input or if module is connected to USB +5V output 
• TX (Pin3) - This is the UART transmitter of the module. It outputs the GPS information for application. 
• RX (Pin4) - This is the UART receiver of the module.

• Model: RKI-1510

Product 2/10

Customers who bought this product also purchased...

Cable Ties 100 Pack

Big Pully for track belt 2cm

PC-MCU Serial Link (Serial Port)

High Torque Encoder DC Servo Motor 60RPM with UART/I2C/PPM Drive

NEMA23 Stepper Motor 10Kgcm Torque

RF 2.4GHz USB Link